Pentax K20D Manual de usuario descargar pdf (Pagina 148)

147

Using the Flash

Wireless Shooting

Using a Combination of the Built-in Flash and an External Flash

Unit

1 Remove the external flash unit for which the channel was set on the

camera, and place at the desired location.

2 Set the flash mode of the camera to r , and pop up the built-in flash.

3 Confirm that both flashes are fully charged and then take the picture.

Using a Combination of External Flash Units

1 Set the wireless mode of the external flash directly connected to the

camera to [MASTER] or [CONTROL].

2 On the flash connected to another flash unit, set the wireless flash mode

to [SLAVE] and set the channel to the same channel as the camera.

Then, place at the desired location.

3 Confirm that both flashes are fully charged and then take the picture.

HSb (High-speed sync) is not available when the camera is set to discharge

the built-in flash.

MASTER

Discharges both the flash directly connected to the camera and

the flash connected to another flash unit.

CONTROL

The flash directly connected to the camera is discharged as a

test flash only and does not discharge as main flash.

Shake Reduction is not available in Wireless mode.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 285 286

Sin comentarios

Pentax K20D Manual de usuario Pagina 148